Sometimes we walk out of our apartments when we are late for class, or for work. All over sudden, we realize that the car battery won’t start. Someone passes by and inquired if they can assist with their jump. We look down with embarrassment at the ground, hit or kick some rocks while contemplating if we should accept their request or just ignore. In some cases, we ask ourselves if we have any clue on how to jump start a car. It is advisable for everyone to know and have knowledge of jumping starting a dead car battery (Chase, 2005). You never know when you will require the knowledge to help when stranded in traffic instead of trying to push the car out of the road.
Jump starting a car battery is one of the practical that car owners need to understand. Surprisingly, most people might not have the knowledge for jump starting a car battery. Additionally, for those who have done it before, might get confused where cables should be attached to. Negative on positive? Ground the negative cable instead of the positive on a vehicle with a new battery? I Is red cable positive or negative? This are some of the aspects that confuse car owners. To assist people to elude looking like as if they have no idea what car maintenance is when requested to jump start a car, the paper provides the steps on how to jump start a car battery.
Use your promo and get a custom paper on
"Jump Starting A Car Battery".
Before making an attempt to jump start a car, it is recommended to determine if the car battery is the reason that is making a car not to star. When turning the ignition and the engine makes a cranking sound, then a car battery won’t be the problem and therefore, jump starting is not the solution (Chase, 2005). On the other hand, when the ignition is turned on and the car does not do anything, then probably a dead battery is in your car and jump starting might be the ticket to get you back on the move.
The first step is to ensure that both the cars are switched off. The second step is to make a connection of one end of the jumper cable, the positive or red cable to the stalled battery’s positive terminal. The third step is to connect the other positive or red cable clamp on to the good battery’s positive terminal. The fourth step, connect one of the black or negative end of the jumper cable to the good battery’s negative terminal. The fifth step is to connect the other negative or black cable to unpainted clean metal surface under the hood of the disabled car. A good recommended place is an area on the engine block. Never dare to connect the negative end of the cable to the negative terminal of the battery which is dead unless you are willing to experience a possible explosion and flying sparks. The sixth step is to ignite the car which is doing the jump starting. Then leave the car to run for approximately 2 to 4 minutes and then ignite the dead car. The seventh step is to eliminate the cables in reverse order. The last step is to leave the jumped car to run for a period of more than 30 minutes in order to provide the initially dead battery enough time to recharge itself. After you are done with the simple but ignored practical knowledge (Chase, 2005). Consequently, thumb yourself on the chest of a job well done. It is important to remember where each cable should be clumped to avoid explosions and flying sparks or else you will broke out with sweat.
